Death Warrant Forums

Please help with path nodes...

--------------------------------------------------------------------------------

I am making my second map, since my first map is on version 5 now, and I encountered a problem.

While putting shelves static meshes up, and trying to put adrenaline, ammo and health on them... shelves... I got an error after I rebuild that states there are no paths from the pick up objects.

So I added a path node right on top of it, rebuilt again and then states that the path node can't go on there.

What am I doing wrong here?
Why wont the items sit on the shelves just nice without errors?

I mean... isn't why the shelves static meshes are for? ... to put pickups in them?

I have seen a map online with shelves and pickups on them and the map is obviously working fine... so why isn't mine?

As Ant said, the pickups in Invasion are intended for human players, so they do not need to have paths to them (i.e. the bots/monsters do not need to get to them so they do not need paths to get there). You just need to make sure that the players can physically get to the pickups (i.e. make sure they are not too far back on the shelves or under a low overhang where the players can't physically get to).

Similarly, if you had a demer pickup that was up on a high ledge (so players had to trans or fly to get it) you would not need to worry that there are no paths to this secluded pickup.

Do you have to add path nodes to a MMA-inv-server

That's the problem though, i tested the map and i can't get the pick ups... never mind the bots.

This is what I came up with...

I went to the shelves properties>collision, and modified some of the properties and kept trying diferent things.

The following set up works, but you can also go throught the shelves:

Block Actors = false
Block Karma = false
Collide Actors = false
Path Colliding = false
Proj Target = false
Use Cylinder Collision = false

Now, is there a way to modify some of these to make you be able to pickup the items without going through the shelves?

If you can't get to the pickups, then there is
(a) Not enough room for you to fit on top of your shelves (Low ceiling)
(b) Poor collision defined for the shelves. use blocking volumes instead.

Thanks Ant, and the collision radius is in the properties?

I assume that's where I change it?

Nelsoncarmo26 wrote:Thanks Ant, and the collision radius is in the properties?

I assume that's where I change it?

You may increase the collision radius through the pickup's properties ---> collision category.